![]() The MCETOOLV2 is supported by the following software tools: If the switch is in an upward position, the target is powered by MCETOOLV2 and if it’s in a downward position, the target is powered by an external source. Switch SW1 is used to power target from isolated DC-DC converted on MCETOOLV2. The pinout for the JTAG connector (J3) is as shown in the figure below To use as an isolated USB to JTAG converter, the PC USB cable plugs into “USB-JTAG”, and the JTAG output port is used. “99 Series Installer” and “100 Series Installer”) Tools are delivered as a part of the Installer package (e.g. Infineon provides the respective PC tools (MCEProgrammer & MCEDesigner) for download on the The MCETOOLV2 can also be used for motor and inverter board parameter tuning via the UART to USB interface. MCETOOLV2 (formerly ‘IR Cable V2’) is designed to program and debug IRMCK099/ IRMCx100/ IRMCx300 series iMOTION™ motor control ICs on the user’s target board (final application board) or on IRMCx evaluation boards.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |